Dell Force10 S4820T S4820T Configuration Guide - Page 785

• Set send and receive version on page 788 (optional) • Generate a default route on page 790 (optional) • Control route metrics on page 791 (optional) • Summarize routes on page 790 (optional) • Control route metrics on page 791 • Debug RIP on page 791 For a complete listing of all commands related to RIP, refer to the FTOS Command Reference. Enable RIP globally By default, RIP is not enabled in FTOS. To enable RIP, use the following commands in sequence, starting in the CONFIGURATION mode: Step 1 Command Syntax router rip 2 network ip-address Command Mode CONFIGURATION ROUTER RIP Purpose Enter ROUTER RIP mode and enable the RIP process on FTOS. Assign an IP network address as a RIP network to exchange routing information. You can use this command multiple times to exchange RIP information with as many RIP networks as you want. After designating networks with which the system is to exchange RIP information, ensure that all devices on that network are configured to exchange RIP information. The FTOS default is to send RIPv1, and to receive RIPv1 and RIPv2. To change the RIP version globally, use the version command in the ROUTER RIP mode. When RIP is enabled, you can view the global RIP configuration by using the show running-config command in the EXEC mode or the show config command shown in the following example in the ROUTER RIP mode. Figure 39-1. show config Command Example in ROUTER RIP mode FTOS(conf-router_rip)#show config ! router rip network 10.0.0.0 FTOS(conf-router_rip)# When the RIP process has learned the RIP routes, use the show ip rip database command in the EXEC mode to view those routes as shown in the following example. Routing Information Protocol (RIP) | 785