Dell Force10 S4820T S4820T Configuration Guide - Page 890

www.dell.com | support.dell.com Task Command Figure 45-4. Reading the Value of the Next Managed Object in the MIB > snmpgetnext -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1.3.0 SNMPv2-MIB::sysContact.0 = STRING: > snmpgetnext -v 2c -c mycommunity 10.11.131.161 sysContact.0 Read the value of many objects at once, as snmpwalk -v version -c community agent-ip {identifier.instance | shown in Figure 45-5. descriptor.instance} Figure 45-5. Reading the Value of Many Managed Objects at Once > snmpwalk -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1 SNMPv2-MIB::sysDescr.0 = STRING: Dell Force10 Real Time Operating System Software Dell Force10 Operating System Version: 1.0 Dell Force10 Application Soft;ware Version: E_MAIN4.7.6.350 Copyright (c) 1999-2007 by Dell Force10 Build Time: Mon May 12 14:02:22 PDT 2008 SNMPv2-MIB::sysObjectID.0 = OID: SNMPv2-SMI::enterprises.6027.1.3.1 DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (32920954) 3 days, 19:26:49.54 SNMPv2-MIB::sysContact.0 = STRING: Write Managed Object Values You may only alter (write) a managed object value if your management station is a member of the same community as the SNMP agent, and the object is writable. To write or write-over the value of a managed object: Task To write or write-over the value of a managed object, as shown in Figure 45-6. Command snmpset -v version -c community agent-ip {identifier.instance | descriptor.instance}syntax value Figure 45-6. Writing over the Current Value of a Managed Object > snmpset -v 2c -c mycommunity 10.11.131.161 sysName.0 s "R5" SNMPv2-MIB::sysName.0 = STRING: R5 Configure Contact and Location Information using SNMP You may configure system contact and location information from the Dell Force10 system or from the management station using SNMP. 890 | Simple Network Management Protocol (SNMP)