Dell MX9116n EMC SmartFabric OS10 User Guide - Page 1140

Command Mode TRUST-MAP Usage Information If the trust map does not define DSCP values to any traffic class, those flows map to the default traffic class 0. If some of the DSCP values are already mapped to an existing traffic class, you will see an error. The no version of this command returns the value to the default. Example OS10(conf-tmap-dscp-qos)# qos-group 5 dscp 42 Supported Releases 10.3.0E or later qos-map traffic-class Creates a user-defined trust map for queue mapping. Syntax qos-map traffic-class map-name Parameters map-name - Enter the name of the queue trust map. A maximum of 32 characters. Default Not configured Command Mode CONFIGURATION Usage Information If applied on the interface or system level, the traffic class routes all traffic to the mapped queue. The no version of this command returns the value to the default. Example OS10(config)# qos-map traffic-class queue-map1 OS10(config-qos-map)# queue 1 qos-group 5 OS10(config-qos-map)# queue 2 qos-group 6 OS10(config-qos-map)# queue 3 qos-group 7 OS10(config-qos-map)# Supported Releases 10.3.0E or later qos-rate-adjust Configures additional number of data bytes to add to overhead fields per frame for rate calculations. Syntax qos-rate-adjust [value-of-adjust] Parameters value-of-adjust-Number of bytes to add to overhead fields in each frame, from 1 to 31. Default 0 Command Mode CONFIGURATION Usage Information The no form of this command removes the rate adjustment configuration and is the same as using the qosrate-adjust 0 command. Example OS10(config)# qos-rate-adjust 10 Supported Releases 10.4.3.0 or later queue-limit Configures static or dynamic shared buffer thresholds. Syntax Parameters queue-limit {queue-len value | thresh-mode [dynamic threshold-alpha-value | static threshold-value]} • queue-len value - Enter the guaranteed size for the queue, from 0 to 8911. 1140 Quality of service