Dell MX9116n EMC SmartFabric OS10 User Guide - Page 657

Default 10 seconds Command Mode INTERFACE Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30 Supported Releases 10.3.0E or later ipv6 ospf network Sets the network type for the interface. Syntax Parameters ipv6 ospf network {point-to-point | broadcast} • point-to-point - Sets the interface as part of a point-to-point network. • broadcast - Sets the interface as part of a broadcast network. Default Broadcast Command Mode INTERFACE Usage Information The no version of this command resets the value to the default. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ipv6 ospf network broadcast Supported Releases 10.3.0E or later ipv6 ospf passive Configures an interface as a passive interface and suppresses both receiving and sending routing updates to the passive interface. Syntax ipv6 ospf passive Parameters None Default Not configured Command Mode INTERFACE Usage Information You must configure the interface before setting the interface to passive mode. The no version of the this command disables Passive interface configuration. NOTE: As loopback interfaces are implicitly passive, the configuration to suppress sending and receiving of OSPF routing updates does not take effect on the loopback interfaces. However, network information corresponding to these loopback interfaces is still announced in OSPF LSAs that are sent through other interfaces configured for OSPF. Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf passive Supported Releases 10.3.0E or later ipv6 ospf priority Sets the priority of the interface to determine the DR for the OSPFv3 network. Syntax Parameters ipv6 ospf priority number number - Enter a router priority number, from 0 to 255. Layer 3 657