Dell MX9116n EMC SmartFabric OS10 User Guide - Page 477

ip vrf forwarding vrf-test Before assigning a n interface to a VRF instance, ensure that no IP address is configured on the interface. 3. Assign an IPv4 address to the interface. INTERFACE CONFIGURATION ip address 10.1.1.1/24 4. Assign an IPv6 address to the interface. INTERFACE CONFIGURATION ipv6 address 1::1/64 You can also auto configure an IPv6 address using the ipv6 address autoconfig command. Assign an interface back to the default VRF instance Table 41. Configurations to be deleted CONFIGURATION MODE IP address-In interface configuration mode, undo the IP address configuration. INTERFACE CONFIGURATION Port-In interface configuration mode, INTERFACE CONFIGURATION delete the interface association corresponding to the VRF instance that you want to delete. COMMAND OS10(conf-if-eth1/1/10:1)#no ip address ipv4-address or no ipv6 address ipv6- address OS10(conf-if-eth1/1/10:1)#no ip vrf forwarding To assign an interface back to the default VRF, perform the following steps: 1. Enter the interface that you want to assign back to the default VRF instance. CONFIGURATION interface ethernet 1/1/1 2. Remove the IPv4 address associated with the interface. INTERFACE CONFIGURATION no ip address 3. Remove the IPv6 address associated with the interface. INTERFACE CONFIGURATION no ipv6 address 4. Assign the interface back to the default VRF instance. INTERFACE CONFIGURATION no ip vrf forwarding Assigning the management interface back to the default VRF instance To assign the management interface back to the default VRF, perform the following steps: 1. Enter the management VRF instance. CONFIGURATION ip vrf management 2. Remove the IPv4 address associated with the interface. INTERFACE CONFIGURATION no ip address 3. Remove the IPv6 address associated with the interface. INTERFACE CONFIGURATION no ipv6 address 4. Assign the management interface back to the default VRF instance. CONFIGURATION VRF no interface management Layer 3 477