Dell MX9116n EMC SmartFabric OS10 User Guide - Page 229

0 class 2 frames, 33 class 3 frames 0 BB credit 0, 0 oversize frames 6356027325 total errors Rate Info: Input 116 bytes/sec, 1 frames/sec, 0% of line rate Output 78 bytes/sec, 1 frames/sec, 0% of line rate Time since last interface status change: 00:00:24 Configuring wavelength You can configure optical transmission wavelength values for SPF+ optics. This configuration enables you to fine tune the laser wavelengths and frequencies up to two decimal places in the nanometer scale. To configure and view optical transmission wavelength when SPF+ optics are plugged into an interface: 1. In interface configuration mode, enter the following command: wavelength wavelength-value NOTE: The supported wavelength range is from 1528.38 nm to 1568.77 nm. OS10(conf-if-eth1/1/14)# wavelength 1530.00 2. View the optical transmission values that you configured using the following command: show interface phy-eth interface transceiver | grep "Tunable wavelength" OS10# show interface phy-eth 1/1/14 transceiver | grep "Tunable wavelength" SFP1/1/14 Tunable wavelength= 1530.000nm NOTE: To specify the wavelength value, you must enter exactly six digits - four before and two after the decimal point. The value must conform to the following format: ABCD.EF; for example, 1545.23. Any number that does not conform to this format is rejected including whole numbers such as 1568. However, the following type of values are accepted: 1568.00. Management interface The Management interface provides OOB management access to the network device. You can configure the Management interface, but the configuration options on this interface are limited. You cannot configure gateway addresses and IP addresses if it appears in the main routing table. Proxy ARP is not supported on this interface. 1. Configure the Management interface in CONFIGURATION mode. interface mgmt 1/1/1 2. By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode. no ip address dhcp 3. Configure an IP address and mask on the Management interface in INTERFACE mode. ip address A.B.C.D/prefix-length 4. Enable the Management interface in INTERFACE mode. no shutdown Configure management interface OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# no ip address dhcp OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24 OS10(conf-if-ma-1/1/1)# no shutdown Interfaces 229