Dell MX9116n EMC SmartFabric OS10 User Guide - Page 627

ip ospf network Sets the network type for the interface. Syntax Parameters ip ospf network {point-to-point | broadcast} • point-to-point - Sets the interface as part of a point-to-point network. • broadcast - Sets the interface as part of a broadcast network. Default Broadcast Command Mode INTERFACE Usage Information The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/1)# ip ospf network broadcast Supported Releases 10.2.0E or later ip ospf passive Configures an interface as a passive interface and suppresses both receiving and sending routing updates to the passive interface. Syntax ip ospf passive Parameters None Default Not configured Command Mode INTERFACE Usage Information You must configure the interface before setting the interface to Passive mode. The no version of the this command disables the passive interface configuration. NOTE: As loopback interfaces are implicitly passive, the configuration to suppress sending and receiving of OSPF routing updates does not take effect on the loopback interfaces. However, network information corresponding to these loopback interfaces is still announced in OSPF LSAs that are sent through other interfaces configured for OSPF. Example OS10(conf-if-eth1/1/6)# ip ospf passive Supported Releases 10.2.0E or later ip ospf priority Sets the priority of the interface to determine the DR for the OSPF network. Syntax ip ospf priority number Parameters number - Enter a router priority number, from 0 to 255. Default 1 Command Mode INTERFACE Usage Information When two routers attached to a network attempt to become the DR, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/6)# ip ospf priority 4 Supported Releases 10.2.0E or later Layer 3 627