Dell MX9116n EMC SmartFabric OS10 User Guide - Page 378

• If all the ports in a port channel have same port priority, the switch internally compares the interface names by base name, module number, port number, and then selects the lowest one to be active. For example, Ethernet 1 is less than Ethernet 2 and hence Ethernet 1 becomes active. • In a VLT network, if the interface name is the same on both the VLT peers, then the port in switch with lower system MAC address becomes active. Limitations • OS10 switches cannot be a PXE client irrespective of whether it acts as a VLT peer or ToR switch. • If you are configuring LACP fallback in a VLT domain, configure lacp fallback commands in both the VLT peers. • If you do not enable LACP fallback in one of the VLT peers, or configure different time-out values in the peers, then the switch might behave differently. • The LACP fallback feature adds or groups a member port to the port channel only when the switch does not receive LACP PDUs from the peer, to make the link that is connected to the PXE client device as operational. As PXE clients handle untagged DHCP request, you need to configure the LACP fallback only on an untagged VLAN to reach the DHCP/PXE server. • After the LACP fallback election, if a port with lower priority port is configured to be part of the same port channel, it would trigger reelection. Configure LACP fallback 1. Enable LACP fallback with the lacp fallback enable command in port channel INTERFACE mode. 2. Set a timer for receiving LACP PDUs using lacp fallback timeout timer-value in port channel INTERFACE mode. 3. (Optional) Enable or disable LACP fallback port preemption using lacp fallback preemption {enable | disable} in port channel INTERFACE mode. Example configuration OS10# configure terminal OS10(config)# interface port-channel 1 OS10(conf-if-po-1)# lacp fallback enable OS10(conf-if-po-1)# lacp fallback timeout 20 OS10(conf-if-po-1)# lacp fallback preemption enable View LACP fallback configuration OS10# show port-channel summary Flags: D - Down I - member up but inactive P - member up and active U - Up (port-channel) F - Fallback enabled Group Port-Channel Type Protocol Member Ports 1 port-channel1 (UF) Eth DYNAMIC 1/1/10(P) 1/1/11(I) LACP fallback in non-VLT network In a non-VLT network, LACP fallback enables rebooting of ToR or server that is connected to the switch through normal LACP. The other end of the switch is connected to a DHCP/PXE server, as shown in the following figure: 378 Layer 2