Dell MX9116n EMC SmartFabric OS10 User Guide - Page 561

non-deterministic-med Compares paths in the order they arrive. Syntax non-deterministic-med Parameters None Default Disabled Command Mode ROUTER-BGP Usage Information Paths compare in the order they arrive. OS10 uses this method to choose different best paths from a set of paths, depending on the order they are received from the neighbors. MED may or may not be compared between adjacent paths. When you change the path selection from deterministic to nondeterministic, the path selection for the existing paths remains deterministic until you use the clear ip bgp command to clear the existing paths. The no version of this command configures BGP bestpath selection as non-deterministic. NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands: 1. Enter the ROUTER BGP mode using the router bgp as-number command. 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# non-deterministic-med Supported Releases 10.2.0E or later outbound-optimization Enables outbound optimization for IBGP peer-group members. Syntax outbound-optimization Parameters None Default Not configured Command Mode ROUTER-BGP Usage Information Enable or disable outbound optimization dynamically to reset all neighbor sessions. When you enable outbound optimization, all peers receive the same update packets. The next-hop address chosen as one of the addresses of neighbor's reachable interfaces is also the same for the peers. The no version of this command disables outbound optimization. NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands: 1. Enter the ROUTER BGP mode using the router bgp as-number command. 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# outbound-optimization Supported Releases 10.3.0E or later password Configures a password for message digest 5 (MD5) authentication on the TCP connection between two neighbors. Syntax Parameters password {9 encrypted password-string| password-string} • 9 encrypted password-string-Enter 9 then the encrypted password. Layer 3 561