Dell MX9116n EMC SmartFabric OS10 User Guide - Page 290

Eth 1/1/7 Eth 1/1/8 Eth 1/1/9 Eth 1/1/10 Eth 1/1/11 Eth 1/1/12 Eth 1/1/13 Eth 1/1/14 Eth 1/1/15 Eth 1/1/16 ... down 0 down 0 down 0 down 0 up 25G down 0 down 0 down 0 down 0 down 0 auto auto auto auto auto auto auto auto auto A 1 A 1 A 1 A 1 A 1 A 1 A 1 A 1 A 1 A 1 - Replace MX Ethernet IO modules in SmartFabric OS10 enables you to replace an Ethernet I/O module (IOM) that is part of a SmartFabric, when an error occurs. The replacement mechanism is available for the following IOMs: • MX9116n Fabric Switching Engine (FSE) • MX5108n Ethernet Switch For information about the MX modules and fabrics, see the Dell EMC PowerEdge MX7000 documentation. For more information about the operating modes and chassis, see Dell EMC OpenManage Enterprise - Modular documentation. The documents are available at the Dell EMC Networking website at www.dell.com/support. Deployment instructions Dell EMC recommends: • The replacement IOM must be a new device in the chassis deployment. NOTE: New device means an IOM that is not deployed previously within the OME-Modular multi-chassis group. • The other IOM in the SmartFabric must be up and running. • The new IOM must be the same model as the faulty IOM. For example: If the faulty IOM model is MX9116n FSE, you must use a new MX9116n FSE as a replacement IOM. • The new IOM must have the same OS10 version as the faulty IOM. You can check the OS10 version by logging into the OME-Modular Graphical User Interface (GUI). NOTE: OS10 is factory-installed in the MX9116n FSE or MX5108n Ethernet Switch. If the faulty IOM has an upgraded version of OS10, you must upgrade the new IOM to the same version. To upgrade an OS10 image, see Download OS10 image for upgrade. Replace an IOM in SmartFabric To replace an IOM that is part of a SmartFabric: 1. Physically remove the faulty IOM and insert the new IOM, see Remove and replace the IOM. 2. Verify the firmware version and configure the IOM settings, see Verify and configure IOM settings. 3. Identify the master IOM connected in the PowerEdge MX chassis, see Identify the master IOM. 4. Initiate the replacement workflow from the master IOM using the module replacement command, see Initiate the module replacement workflow. The module replacement command is a Linux command that must be executed from the Linux shell. 5. Connect the cables to the new IOM, see Connect the cables to the new IOM. Master and member IOMs: A single MX chassis supports four Ethernet IOMs, where one IOM is the master and the remaining three are members. In a multiple chassis environment, of all the IOMs connected in a scalable fabric, one IOM is the master and the remaining are members. Remove and replace the faulty IOM 1. Identify the faulty IOM to replace. 2. Label each of the cables with the port numbers before disconnecting the cables. 3. Remove the faulty IOM. 4. Insert the new IOM into the empty slot. NOTE: Do not reconnect the cables. 290 PowerEdge MX Ethernet I/O modules