Dell MX9116n EMC SmartFabric OS10 User Guide - Page 207

Usage Information Use the pool command to name the pool of available IP addresses used by a DHCP server to assign an IP address to a client and enter DHCP POOL mode. In this mode, use the network command to configure the IPv4 or IPv6 subnet from which the DHCP server assigns addresses. Example OS10(conf-dhcp)# pool Dell OS10(conf-dhcp-Dell)# Supported Releases 10.2.0E or later range Configures a range of IP addresses. Syntax Parameters range {ip-address1 [ip-address2]} • ip-address1 - First IP address of the IP address range. • ip-address2 - Last IP address of the IP address range. Default Not configured Command Mode DHCP-POOL Usage Information Use the range command to configure a range of IP addresses that the OS10 switch, acting as the DHCP server, can assign to DHCP clients. The no version of this command requires only the first IP address to remove the range configuration. Example OS10(config)# OS10(config)# ip dhcp server OS10(config-dhcp)# pool pool1 OS10(config-dhcp-pool1)# network 192.168.10.0/24 OS10(config-dhcp-pool1)# range 192.168.10.2 192.168.10.8 Supported Releases 10.4.1 or later show ip dhcp binding Displays the DHCP binding table with IPv4 addresses. Syntax show ip dhcp binding Parameters None Default Not configured Command Mode EXEC Usage Information After configuring a static IP-to-MAC address mapping with the host and hardware-address commands in DHCP POOL mode, use this command to verify the single manual binding for a host in the DHCP binding table. Example OS10# show ip dhcp binding IP Address Hardware address Lease expiration Hostname 11.1.1.254 00:00:12:12:12:12 Jan 27 2016 06:23:45 Total Number of Entries in the Table = 1 Supported Releases 10.2.0E or later System management 207