Dell MX9116n EMC SmartFabric OS10 User Guide - Page 346

Example Supported Releases OS10(config)# interface fibrechannel 1/1/1 OS10(conf-if-fc1/1/1)# vfabric 100 OS10(config)# interface ethernet 1/1/10 OS10(conf-if-eth1/1/10)# vfabric 200 10.3.1E or later vlan Associates an existing VLAN ID to the vfabric to carry traffic. Syntax vlan vlan-ID Parameters vlan-ID - Enter an existing VLAN ID. Defaults Not configured Command Mode Vfabric CONFIGURATION Usage Information Create the VLAN ID before associating it to the vfabric. Do not use spanned VLAN as vfabric VLAN. The no version of this command removes the VLAN ID from the vfabric. Example OS10(config)# interface vlan 1023 OS10(conf-if-vl-1023)# exit OS10(config)# vfabric 100 OS10(conf-vfabric-100)# vlan 1023 Supported Releases 10.3.1E or later FIP-snooping commands The following commands are supported on FIP-snooping mode: feature fip-snooping Enables the FIP snooping feature globally. Syntax feature fip-snooping [with-cvl] Parameters with-cvl-To enable CVL. Defaults Disabled Command Mode CONFIGURATION Usage Information You can enable only one of the following at a time: F_Port, NPG, or FSB. You can include the with-cvl option to send a Clear Virtual Link (CVL) frame from the FCF to the ENode. This option helps the system to recover automatically if an FCoE session drops. If FIP snooping is already enabled, you can enter the feature fip-snooping with-cvl command to enable CVL. You do not have to explicitly disable FIP snooping to enable CVL. However, to disable CVL, you must disable FIP snooping and then re-enable it without the with-cvl option. The no version of this command disables FIP snooping. When you disable FIP snooping, the system automatically deletes all the FIP snooping VLAN and port mode configurations. If any FIP snooping-related configurations are present in the system, OS10 returns an error message. You can only disable FIP snooping after you remove all the FIP snooping-related configurations from the system. 346 Fibre Channel