Dell MX9116n EMC SmartFabric OS10 User Guide - Page 950

Command Mode EXEC Usage Information By default, the password you configure with the username password command must be at least nine alphanumeric characters. Use this command to increase password strength. When you enter the command, at least one parameter is required. When you enter the character-restriction parameter, at least one option is required. To reset parameters to their default values, use the no password-attributes command. Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S). Also supported in SmartFabric mode starting in release 10.5.0.1. Example OS10(config)# password-attributes min-length 6 character-restriction upper 2 lower 2 numeric 2 Supported Releases 10.4.0E(R1) or later password-attributes max-retry lockout-period Configures a maximum number of consecutive failed login attempts and the lockout period for the user ID. Syntax Parameters password-attributes {[max-retry number] [lockout-period minutes]} • max-retry number - (Optional) Sets the maximum number of consecutive failed login attempts for a user before the user is locked out, from 0 to 16. • lockout-period minutes - (Optional) Sets the amount of time that a user ID is prevented from accessing the system after exceeding the maximum number of failed login attempts, from 0 to 43,200. Default • Maximum number of retries: 3 • Lockout period: 0 - No lockout period is configured. Failed login attempts do not lock out a user. Command Mode CONFIGURATION Usage Information To remove the configured max-retry or lockout-period settings, use the no password-attributes {max-retry | lockout-period} command. When a user is locked out due to exceeding the maximum number of failed login attempts, other users can still access the switch. Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.1.0. Also supported in SmartFabric mode starting in release 10.5.0.1. Example OS10(config)# password-attributes max-retry 5 lockout-period 30 Supported Releases 10.4.1.0 or later privilege Creates a privilege level and associates commands with it. Syntax Parameters privilege mode priv-lvl privilege-level command-string • mode - Enter the privilege mode used to access CLI modes: • exec - Accesses EXEC mode. • configure - Accesses class-map, DHCP, logging, monitor, openflow, policy-map, QOS, support-assist, telemetry, CoS, Tmap, UFD, VLT, VN, VRF, WRED, and alias modes. • interface - Accesses Ethernet, fibre-channel, loopback, management, null, port-group, lag, breakout, range, port-channel, and VLAN modes. 950 Security