Dell MX9116n EMC SmartFabric OS10 User Guide - Page 277

Example Supported Releases • To change the port profile on a switch, use the switch-port-profile command with the desired profile, save it to the startup configuration and use the reload command to apply the change. The switch reboots with new port configuration. The no version of the command resets to the default profile. When a switch reloads with a new port profile, the startup configuration resets to system defaults, except for the switch-port profile and these configured settings: • Management interface 1/1/1 configuration • Management IPv4/IPv6 static routes • System hostname • Unified Forwarding Table (UFT) mode • ECMP maximum paths You must manually reconfigure other settings on a switch after you apply a new port profile and use the reload command to apply the change. OS10(config)# switch-port-profile 1/1 profile-1 Warning: Switch port profile will be applied only after a save and reload. All management port configurations will be retained but all other configurations will be wiped out after the reload. OS10(config)# do write memory OS10(config)# do reload 10.3.0E or later switchport access vlan Assigns access VLAN membership to a port in L2 Access or Trunk mode. Syntax switchport access vlan vlan-id Parameters vlan vlan-id - Enter the VLAN ID number, from 1 to 4093. Default VLAN 1 Command Mode INTERFACE Usage Information This command enables L2 switching for untagged traffic and assigns a port interface to default VLAN1. Use this command to change the assignment of the access VLAN that carries untagged traffic. You must create the VLAN before you can assign an access interface to it. The no version of this command resets access VLAN membership on a L2 access or trunk port to VLAN 1. Example OS10(conf-if-eth1/1/3)# switchport mode access OS10(conf-if-eth1/1/3)# switchport access vlan 100 Supported Releases 10.2.0E or later switchport mode Places an interface in L2 Access or Trunk mode. Syntax Parameters switchport mode {access | trunk} • access - Enables L2 switching of untagged frames on a single VLAN. • trunk - Enables L2 switching of untagged frames on the access VLAN, and of tagged frames on the VLANs specified with the switchport trunk allowed vlan command. Default Command Mode access INTERFACE Interfaces 277