Dell MX9116n EMC SmartFabric OS10 User Guide - Page 1191

discovery-interface Configures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers. Syntax discovery-interface {ethernet node/slot/port[:subport]} Parameters ethernet - Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of interfaces separated by hyphens and commas. Default None Command Mode VLT-DOMAIN Usage Information The VLT node discovery service automatically connects the discovery port to its peer node port and creates VLTi interfaces. The no version of this command disables the discovery-interface configuration. Example OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15 Example (range) OS10(config)# vlt-domain 2 OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12 Supported Releases 10.2.0E or later peer-routing Enables optimized routing where packets destined for the L3 endpoint of the VLT peer are locally routed. Syntax peer-routing Parameters None Default Disabled Command Mode VLT-DOMAIN Usage Information The no version of this command disables peer routing. Example OS10(conf-vlt-1)# peer-routing Supported Releases 10.2.0E or later peer-routing-timeout Configures the delay after which, the system disables peer routing when the peer is not available. This command supports both IPv6 and IPv4 routing. Syntax peer-routing-timeout value Parameters value - Enter the timeout value in seconds, from 0 to 65535. Default 0 Command Mode VLT-DOMAIN Usage Information When the timer expires, the system checks to see if the VLT peer is available. If the VLT peer is not available, the system disables peer-routing on the peer. If you do not configure the timer, the system does not disable peerrouting even when the peer is unavailable. Example OS10(conf-vlt-1)# peer-routing-timeout 120 Virtual Link Trunking 1191