Dell MX9116n EMC SmartFabric OS10 User Guide - Page 174

reference ID: reference time: system jitter: clock jitter: clock wander: broadcast delay: symm. auth. delay: OS10# 10.0.0.1 dbc7b087.5d47aaa6 0.000000 0.462 0.003 -50.000 0.000 Sat, Nov 5 2016 1:12:39.364 5. Verify that the NTP server (10.0.0.1) is connected to the NTP master (11.0.0.2) running in VRF Red. OS10(config)# do show ntp associations vrf red remote refid st t when poll reach delay offset jitter LOCAL(0) .LOCL. 8 l 111 64 2 0.000 0.000 0.000 *11.0.0.2 LOCAL(0) 9 u 43 64 3 0.441 0.026 0.047 OS10(config)# do show ntp status vrf red associd=0 status=0615 leap_none, sync_ntp, 1 event, clock_sync, system peer: 11.0.0.2:123 system peer mode: client leap indicator: 00 stratum: 10 log2 precision: -24 root delay: 0.441 root dispersion: 950.580 reference ID: 11.0.0.2 reference time: dbc7b03e.733f51d7 Sat, Nov 5 2016 1:11:26.450 system jitter: 0.000000 clock jitter: 0.009 clock wander: 0.000 broadcast delay: -50.000 symm. auth. delay: 0.000 OS10(config)# NTP commands ntp authenticate Enables authentication of NTP traffic between the device and the NTP time serving hosts. Syntax ntp authenticate Parameters None Default Not configured Command Mode CONFIGURATION Usage Information You must also configure an authentication key for NTP traffic using the ntp authentication-key command. Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S). Also supported in SmartFabric mode starting in release 10.5.0.1. The no version of this command disables NTP authentication. Example OS10(config)# ntp authenticate Supported Releases 10.2.0E or later 174 System management