Dell MX9116n EMC SmartFabric OS10 User Guide - Page 82

Supported Releases 10.4.3.0 or later system identifier Sets a non-default unit ID in a non-stacking configuration. Syntax system identifier system-id Parameters system-id - Enter the system ID, from 1 to 9. Default Not configured Command Mode CONFIGURATION Usage Information The system ID displays in the stack LED on the switch front panel. Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0(R3S). Also supported in SmartFabric mode starting in release 10.5.0. Example OS10(config)# system identifier 1 Supported Releases 10.3.0E or later terminal Sets the number of lines to display on the terminal and enables logging. Syntax Parameters terminal {length lines | monitor} • length lines - Enter the number of lines to display on the terminal from 0 to 512; default 24. • monitor - Enables logging on the terminal. Default 24 terminal lines Command Mode EXEC Usage Information Enter zero (0) for the terminal to display without pausing. Example OS10# terminal monitor Supported Releases 10.2.0E or later traceroute Displays the routes that packets take to travel to an IP address. Syntax Parameters traceroute [vrf {management | vrf-name}] host [-46dFITnreAUDV] [-f first_ttl] [-g gate,...] [-i device] [-m max_ttl] [-N squeries] [-p port] [-t tos] [-l flow_label] [-w waittime] [-q nqueries] [-s src_addr] [-z sendwait] [-fwmark=num] host [packetlen] • vrf management- (Optional) Traces the route to an IP address in the management VRF instance. • vrf vrf-name - (Optional) Traces the route to an IP address in the specified VRF instance. • host - Enter the host to trace packets from. • -i interface - (Optional) Enter the IP address of the interface through which traceroute sends packets. By default, the interface is selected according to the routing table. • -m max_ttl - (Optional) Enter the maximum number of hops for the maximum time-to-live value that traceroute probes. The default is 30. 82 CLI Basics