Dell MX9116n EMC SmartFabric OS10 User Guide - Page 555

distribute-list Distributes BGP information through an established prefix list. Syntax Parameters distribute-list prefix-list-name {in | out} • prefix-list-name-Enter the name of established prefix list. • in-Enter to distribute inbound traffic. • out-Enter to distribute outbound traffic. Defaults Command Modes None ROUTER-BGP-NEIGHBOR-AF ROUTER-TEMPLATE-AF Usage Information The no version of this command removes the route-map. Example OS10(conf-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# distribute-list inbgg in OS10(conf-router-template)# address-family ipv4 unicast OS10(conf-router-bgp-template-af)# distribute-list outbgg out Supported Releases 10.4.1.0 or later bgp default local-preference Changes the default local preference value for routes exchanged between internal BGP peers. Syntax default local-preference number Parameters number - Enter a number to assign to routes as the degree of preference for those routes. When routes compare, the route with the higher degree of preference or the local preference value is most preferred, from 1 to 4294967295. Default 100 Command Mode ROUTER-BGP Usage Information All routers apply this command setting within the AS. The no version of this command deletes local preference value. Example OS10(conf-router-bgp-1)# default local-preference 200 Supported Releases 10.3.0E or later ebgp-multihop Allows eBGP neighbors on indirectly connected networks. Syntax ebgp-multihop hop count Parameters hop count - Enter a value for the number of hops, from 1 to 255. Default 1 for eBGP. 255 for iBGP. Command Mode ROUTER-NEIGHBOR Usage Information This command avoids installation of default multihop peer routes to prevent loops and creates neighbor relationships between peers. Networks indirectly connected are not valid for best path selection. The no version of this command removes multihop session. Example OS10(conf-router-neighbor)# ebgp-multihop 2 Layer 3 555