Dell PowerEdge 2950 Hardware Owner's Manual (PDF) - Page 67
Removing the Cooling Shroud
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Removing the Cooling Shroud 1 The cooling shroud is secured with a latch at the end of the shroud. Release the latch by pulling it towards the outside wall of the chassis. See Figure 3-10. 2 Rotate the shroud upward and toward the front of the system on its hinges, and then lift the shroud out of the system. Figure 3-10. Removing and Installing the Cooling Shroud 2 3 1 4 5 1 shroud pivots (2) 4 shroud hinges (2) 2 cooling shroud 5 fan bracket 3 release latch Installing the Cooling Shroud 1 Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3-10. 2 Slowly lower the shroud straight down into the system until the fan connector engages and the latches snap into place. Installing System Components 67
Installing System Components
67
Removing the Cooling Shroud
1
The cooling shroud is secured with a latch at the end of the shroud. Release the latch by pulling it
towards the outside wall of the chassis. See Figure 3-10.
2
Rotate the shroud upward and toward the front of the system on its hinges, and then lift the shroud
out of the system.
Figure 3-10.
Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1
Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3-10.
2
Slowly lower the shroud straight down into the system until the fan connector engages and the latches
snap into place.
1
shroud pivots (2)
2
cooling shroud
3
release latch
4
shroud hinges (2)
5
fan bracket
1
3
4
2
5