Dell PowerEdge 2950 Hardware Owner's Manual (PDF) - Page 83
Diskette Drive, Removing the Diskette Drive From the System - tape drive
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Diskette Drive Removing the Diskette Drive From the System CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Remove the front bezel, if attached. See "Removing the Front Bezel" on page 53. 3 Open the system. See "Opening the System" on page 54. 4 If your system configuration includes a tape backup device installed in the optional media bay, remove the tape backup device's strain relief bracket. See "Removing and Replacing the Tape Drive Cable Retention Bracket" on page 88. 5 Disconnect the cable from the back of the diskette drive. 6 Release the diskette drive carrier from its slot in the media bay: a Gently squeeze down on the plastic tabs on the side of the carrier while pushing toward the front of the system until you feel the carrier sliding freely forward. b Slide the carrier forward and out of the chassis. See Figure 3-23. Installing System Components 83