Dell PowerEdge 2950 Hardware Owner's Manual (PDF) - Page 99
Installing the Left Riser Board, into place.
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Figure 3-31. Replacing the Left Riser Board 3 4 5 2 1 1 riser release pin 4 riser securing tabs (6) 2 expansion-card rails 5 riser securing slots (6) 3 expansion-card cage Installing the Left Riser Board CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Place the riser board in the expansion-card cage so that the six securing tabs are fully inserted in the six securing slots on the riser board. See Figure 3-31. 2 Slide the riser board toward the expansion card openings until you feel the riser-board release pin snap into place. 3 Replace the expansion-card cage. See "Replacing the Expansion-Card Cage" on page 79. 4 Install all expansion cards in the expansion-card slots. See "Installing an Expansion Card" on page 76. 5 Close the system. See "Closing the System" on page 55. Installing System Components 99