Dell bpcwcsn_5 User's Guide - Page 226
cable to the integrated network connector on the back panel of the computer.
![]() |
View all Dell bpcwcsn_5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 226 highlights
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 12 If you installed a network adapter card and want to turn off the integrated network adapter: a Enter system setup, select Integrated NIC from the Onboard Devices group, and change the setting to Off (see "System Setup" on page 257). b Connect the network cable to the network adapter card's connectors. Do not connect the network cable to the integrated network connector on the back panel of the computer. 13 Install any drivers required for the card as described in the card documentation. Removing a PCI Card 1 Follow the procedures in "Before You Begin" on page 19. NOTE: For PCI card locations, see "System Board Components" on page 102. 2 Gently lift the release tab on the card retention latch from the inside and pivot the latch open. 3 If necessary, disconnect any cables connected to the card. 4 Grasp the card by its top corners, and ease it out of its connector. 1 2 3 4 5 1 release tab 4 card-edge connector 2 card retention latch 5 card connector 226 Small Form Factor Computer 3 card
![](/manual_guide/products/dell-optiplex-740-users-guide-19f9f5b/226.png)