Dell bpcwcsn_5 User's Guide - Page 58
Removing a PS/2 Serial Port Adapter
View all Dell bpcwcsn_5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
2 1 3 4 1 fully seated card 2 4 bracket caught outside of slot not fully seated card 3 bracket within slot Before you close the card retention mechanism, ensure that: • The tops of all adapters and filler brackets are flush with the alignment bar. • The notch in the top of the adapter or filler bracket fits around the alignment guide. 5 Close the card retention latch and gently press until it snaps into place. NOTICE: Do not route cables over any installed cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment. 6 Connect the adapter cable to the serial port adapter connector (PS2/SER2) on the system board (see "System Board Components" on page 28 for connector locations). NOTE: See the documentation for the PS/2 serial port adapter for information about the cable connections. 7 Replace the computer cover (see "Replacing the Computer Cover" on page 297). Removing a PS/2 Serial Port Adapter 1 Follow the procedures in "Before You Begin" on page 19. 2 Gently push the release tab on the card retention latch from the inside to pivot the latch open. The latch will remain in the open position. 58 Mini Tower Computer