HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 121

AG System Messages Chapter 2 AG-1001 Message Probable Cause Recommended Action Severity , [AG-1001], ,, ERROR, , N_Port ID virtualization (NPIV) is not supported by fabric port connected to port . Indicates that the N_Port ID virtualization (NPIV) capability is not supported by the fabric port to which the Access Gateway is connected. • On switches running Fabric OS 6.0.0 or earlier versions, execute the portCfgNpivPort command to enable NPIV capability on the port connected to the Access Gateway. • Some blades and ports in a switch may not support NPIV. NPIV functionality cannot be enabled on such ports and they will not respond to NPIV requests. Refer to the Access Gateway Administrator Guide, Appendix B, for specific AG-compatibility requirements. • On non-Brocade switches, refer to the manufacturer's documentation to determine whether the switch supports NPIV and how to enable NPIV on these types of switches. ERROR AG-1002 Message , [AG-1002], ,, WARNING, , Unable to find alternate N_Port during failover for N_Port . Probable Cause Indicates that no other N_Port is configured or the fabric was unstable during failover. Recommended Action Check whether or not an alternate N_Port is configured. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING AG-1003 Message Probable Cause , [AG-1003], ,, WARNING, , Unable to failover N_Port . Failover across different fabrics is not supported. Indicates that the failover does not get blocked between two fabrics, although it is not a supported configuration. Fabric OS Message Reference 35 53-1002448-01