HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 337

Chapter FCPH System Messages 36 FCPH-1001 Message , [FCPH-1001], , FFDC, CRITICAL, , : failed, out of memory condition Probable Cause Indicates that the switch is low on memory and failed to allocate new memory for a Fibre Channel driver instance. The function can only be " fc_create". This function creates a Fibre Channel driver instance. The failed function call kmalloc_wrapper has failed. This function call is for kernel memory allocation. Recommended A nonbladed switch will automatically reboot. For a bladed switch, the active CP blade will Action automatically failover and the standby CP will become the active CP. Severity CRITICAL FCPH-1002 Message , [FCPH-1002], ,, WARNING, , Port has been disabled since switch requires authentication when device authentication policy is set to ON. Probable Cause Indicates a device which does not support authentication has tried to log in to the switch when the device authentication policy is in ON status on the switch. Recommended Action Enable the authentication on the device or set the device authentication status to PASSIVE/OFF on the switch if it is not mandatory. Use the authUtil command to change the device authentication policy. Severity WARNING FCPH-1003 Message Probable Cause , [FCPH-1003], ,, WARNING, , New port has same Port WWN with old port as part of duplicate Port WWN detection policy. Indicates that this port is older port of same Port WWN of new port or device. Fabric OS Message Reference 251 53-1002448-01