HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 353

FCR-1058 37 Investigate the other switch for more details. Run the errShow command on the other switch to view the error log for additional messages. Severity ERROR FCR-1058 Message , [FCR-1058], ,, WARNING, , Port isolated due to mismatched configuration parameter; . Probable Cause Indicates that the specified port was isolated after segmentation caused by mismatched configuration parameters or by domain ID assigned by the principal switch that did not match the insistent domain ID of this port. Recommended Action Check the switches on both ends of the link for a possible mismatch in switch or port configuration parameters such as Operating Mode, E_D_TOV, R_A_TOV, Domain ID Offset, etc. Run the portCfgExport command to modify the appropriate parameters on the local switch. Run the appropriate configuration command to modify the switch or port parameters on the remote switch. Severity WARNING FCR-1059 Message , [FCR-1059], ,, INFO, , EX_Port was disabled due to an authentication failure. Probable Cause Indicates that the authentication, which uses the Diffie Hellman - challenge handshake authentication Protocol (DH-CHAP), failed on the EX_Port. Recommended Action Verify that the shared secrets on both sides of the link match. Disable and enable the ports by using the portDisable and the portEnable commands to restart authentication. Severity INFO FCR-1060 Message , [FCR-1060], ,, WARNING, , EX_Port() has an incompatible configuration setting. Probable Cause Indicates that virtual channel (VC) Link Init is enabled on the local switch and the remote switch is negotiating in R_RDY mode. The fabric might not form properly. Recommended Action Check the configuration on the local switch using the portCfgShow command to verify that the VC Link Init is disabled, if the remote switch is configured in R_RDY mode or only capable of R_RDY mode. Fabric OS Message Reference 267 53-1002448-01