HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 689

SEC-1104 94 SEC-1104 Message , [SEC-1104], ,, ERROR, , Fail to get primary . Probable Cause Indicates the switch failed to get either the primary certificate or a primary public key. Recommended Action Verify the primary switch has a valid certificate installed and retry the operation. If a valid certificate is not installed, install a certificate by following the procedure specified in the Secure Fabric OS Administrator's Guide. Severity ERROR SEC-1105 Message , [SEC-1105], ,, ERROR, , Fail to disable secure mode on all switches. Probable Cause Indicates the switch failed to disable security in the fabric. This could happen if the switch cannot get the required resources to complete the command, and sending to a remote domain fails or the remote domain returns an error. Recommended Run the secFabricShow to verify that all switches in the fabric are in the ready state. Retry the Action command when all switches are READY. Severity ERROR SEC-1106 Message , [SEC-1106], ,, ERROR, , Failed to sign message data. Probable Cause Indicates that some public key infrastructure (PKI) objects on the switch are not in a valid state, and a signature operation failed. Recommended Action Run the pkiShow command and verify that all PKI objects exist on the switch. If a failure to validate PKI objects occurs, follow the steps for re-creating PKI objects outlined in the Secure Fabric OS Administrator's Guide. Severity ERROR SEC-1107 Message , [SEC-1107], ,, INFO, , Stamp is 0. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Fabric OS Message Reference 603 53-1002448-01