HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 280

25 EM-1059 EM-1059 Message , [EM-1059], , FFDC, ERROR, , with ID may not be supported on this platform, check FOS firmware version as a possible cause. Probable Cause Indicates that a blade inserted in the specified slot or the switch (for nonbladed switches) is incompatible with the switch configuration software. The system may not be usable. The blade may only be supported by a later (or earlier) version of the firmware. Recommended Change the control processor (CP) firmware or replace the blade. Make sure the replacement is Action compatible with your switch type and firmware. Severity ERROR EM-1060 Message , [EM-1060], ,, WARNING, , Stopping synchronization of the system due to blade incompatibility with software version on standby CP. Probable Cause Indicates that a blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Remove all blades of this type or upgrade your standby CP. After an appropriate action is taken, restart the standby CP or execute the haSyncStart command to enable the High Availability (HA) state synchronization. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1061 Message , [EM-1061], ,, WARNING, , Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. Probable Cause Indicates a blade in the system is not supported by the firmware on the standby control processor (CP). Recommended Action Remove all blades of the specified type or upgrade the standby CP. After an appropriate action is taken, restart the standby CP or execute the haSyncStart command to enable the High Availability (HA) state synchronization. Until this is done, the system will remain out of synchronization. Severity WARNING 194 Fabric OS Message Reference 53-1002448-01