HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 193

C3-1017 12 Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity ERROR C3-1017 Message , [C3-1017], ,, ERROR, , Blade in Slot failed due to unavailability of ports in the internal trunk. Probable Cause Indicates that the blade failed due to unavailability of the ports in the internal trunk. Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity ERROR C3-1018 Message , [C3-1018], ,, ERROR, , Blade in Slot- faulted due to Link reset threshold value exceeded. Probable Cause Indicates that blade is faulted due to Link reset threshold exceeded. Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity ERROR C3-1019 Message , [C3-1019], ,, WARNING, , S,C: HW ASIC Chip TXQ FID parity error threshold reached type = 0x. Probable Cause Indicates that an internal error is observed in the ASIC hardware that may degrade the data traffic. Recommended Whenever this error occurs, restart the system at the next maintenance window. Action Severity WARNING C3-1020 Message Probable Cause , [C3-1020], ,, WARNING, , S,P(): Some non critical CRC with good EOF errors were observed: current:0x, last:0x thresh1:0x. Indicates some errors detected in hardware. Fabric OS Message Reference 107 53-1002448-01