HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 950

137 SULB-1034 SULB-1034 Message AUDIT, , [SULB-1034], ERROR, FIRMWARE, , , Relocation of internal image timed out. Probable Cause Indicates there may be an error caused by a switch initialization issue after the internal image is relocated. It may also be caused by an internal Ethernet issue or by persistent storage failure. Recommended Action Reboot the switch. This will cause the internal image to be relocated again. Use the firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your switch service provider. Severity ERROR SULB-1035 Message AUDIT, , [SULB-1035], ERROR, FIRMWARE, , , , An error has occurred during relocation of the internal image. Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or persistent storage hardware failure. Recommended Reset the switch. This will cause the internal image to be relocated again. If the problem persists, Action contact your switch service provider. Severity ERROR SULB-1037 Message AUDIT, , [SULB-1037], ERROR, FIRMWARE, HCL failed. Reboot the switch manually using the reboot command. However, it will disrupt the FC traffic. Probable Cause Indicates HCL has failed. Many reasons, such as domain not confirmed, can cause this failure. Recommended Run the reboot command to reboot the switch manually. Action Severity ERROR 864 Fabric OS Message Reference 53-1002448-01