HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 839

ZONE System Messages Chapter 115 ZONE-1002 Message , [ZONE-1002], ,, WARNING, , WWN zoneTypeCheck or zoneGroupCheck warning() at port(). Probable Cause Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a failure when creating or adding the zone groups during port login (PLOGI) trap processing. This message usually indicates problems when adding the content-addressable memory (CAM) entries before the filter setup. Recommended If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP Action transfers; then execute the supportSave command and contact your switch service provider. Severity WARNING ZONE-1003 Message , [ZONE-1003], ,, WARNING, , zone() contains (, ) which does not exist. Probable Cause Indicates that the port zone member that is targeted for the local switch contains a nonexistent port. The specified port number in the effective zoning configuration (displayed in the error message) is out of range. Recommended Edit the zone database and change the port number to a viable value in the effective configuration. Action Severity WARNING ZONE-1004 Message Probable Cause , [ZONE-1004], ,, INFO, , port (0x) enforcement changed to Session Based HARD Zoning. Indicates that the zoning enforcement has changed to session-based hard zoning due to one of the following conditions: • The zone has a mix of WWN and domain, index (D,I) members. • The Source Identifier (S_ID) list of the hardware-enforced zoning exceeded the S_ID limit. Fabric OS Message Reference 753 53-1002448-01