HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 162

7 BL-1015 BL-1015 Message , [BL-1015], ,, ERROR, , bport port is faulted. status=0x. Probable Cause Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port; this number might not correspond to a user port number. Recommended Action Make sure to capture the console output during this process. On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, reboot the switch. Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. If there is a hardware error, if the slotPowerOff or slotPowerOn fails on the bladed switch or if errors are encountered again: • On the Brocade 24000, and 48000, replace the blade field-replaceable unit (FRU). • On the Brocade 3900, replace the motherboard FRU. • On the Brocade 200E, 3016, 3250, 3850, or 4100, 4012, 4016, 4018, 4024, 4900, 7500, AP7600, and 5000, replace the switch. Severity ERROR BL-1016 Message , [BL-1016], , FFDC, CRITICAL, , Blade port in slot failed to enable. Probable Cause Indicates that the specified blade port has failed to get enabled. Recommended Action Make sure that the blade is seated correctly. If the blade is seated correctly, restart or power cycle the blade. Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric OS Command Reference for more information on these commands. If the message persists, replace the blade. Severity CRITICAL BL-1017 Message Probable Cause , [BL-1017], ,, INFO, , Slot Initializing... Indicates that the slot has started initializing the ports. 76 Fabric OS Message Reference 53-1002448-01