HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 507

Chapter HAM System Messages 46 HAM-1001 Message , [HAM-1001], , SLOT cp-slpt-number | FFDC | CHASSIS, FFDC, CRITICAL, , Standby CP is not healthy, device status BAD, Severity = . Probable Cause Indicates that a standby control processor (CP) device error is reported by the High Availability Manager (HAM) Health Monitor, with the specified device and Log="YES" Class="NONE" Severity level. The Severity variable can be critical, major, or minor. The active CP will continue to function normally, but because the standby CP is not healthy, non-disruptive failover is not possible. Recommended Restart the standby CP blade by ejecting the card and reseating it. If the problem persists, replace Action the standby CP. Severity CRITICAL HAM-1002 Message , [HAM-1002], , SLOT cp-slot-number | CHASSIS, INFO, , Standby CP is healthy. Probable Cause Indicates that all the standby CP devices monitored by the HAM Health Monitor reported no error. Recommended No action is required. Action Severity INFO HAM-1004 Message Probable Cause , [HAM-1004], , SLOT cp-slot-number | CHASSIS, INFO, , Processor rebooted - . Indicates that the switch has been restarted because of a user action or an error. The switch restart can be initiated using the firmwareDownload, fastBoot, haFailover, and reboot commands. Some examples of errors that may initiate this message are hardware errors, software errors, compact flash errors, or memory errors. The Reboot Reason variable can be any of the following: • Hafailover • Reset • Fastboot Fabric OS Message Reference 421 53-1002448-01