HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 951

137 SULB-1038 SULB-1038 Message AUDIT, , [SULB-1038], WARNING, FIRMWARE, Co-CPU has not booted up properly. Skip the firmwaredownload command on the co-CPU. Probable Cause Indicates that the Main CPU cannot access the co-CPU to update the firmware on the co-CPU or run any other firmwaredownload command on the co-CPU. If firmwareDownload in progress it will continue without updating the co-CPU firmware. Recommended After firmwaredownload completes, reboot the CP manually to bring up the co-CPU and run the Action firmwareDownload command again. If the problem persists, contact the service provider. Severity WARNING SULB-1039 Message AUDIT, , [SULB-1039], INFO, FIRMWARE, CP has completed relocating the internal firmware image. Probable Cause Indicates that the firmwareDownload command process has been completed normally on the CP. Recommended Run the firmwareShow command to verify the firmware versions. Action Severity INFO SULB-1040 Message AUDIT, , [SULB-1040], WARNING, FIRMWARE, , , , An error has occurred during relocation of the internal image on the CP. Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet failure. Recommended Action Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload command again if the firmware is not updated. This will cause the internal image to be relocated again. If the problem persists, contact your switch service provider. Severity WARNING Fabric OS Message Reference 865 53-1002448-01