HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 851

115 ZONE-1048 ZONE-1048 Message , [ZONE-1048], ,, WARNING, , ZONE ACA is rejected on the standby. Probable Cause Indicates that the standby zoning component did not receive a syncdump command from the primary side. Recommended Synchronize the standby control processor (CP) using the haSyncStart command. Action Severity WARNING ZONE-1049 Message , [ZONE-1049], ,, ERROR, , ZONE AD-DefZone conflict detected while system initialization. Probable Cause Indicates that there is an Admin Domain (AD) Default Zone conflict. Recommended Action Verify that the default zoning mode for AD0 is set to No Access using the defzone --show command. If the default zoning mode is not set to No Access, execute the defzone --noaccess command and then execute the cfgsave command to commit the default zone mode change. Severity ERROR ZONE-1050 Message , [ZONE-1050], ,, INFO, , The Interop Safe Zoning mode is set to Enabled. Probable Cause Indicates that the Interop Safe Zoning mode is enabled. Recommended Verify the event was planned. If the event was planned, no action is required. If the event was not Action planned, take appropriate action as defined by your enterprise security policy. Severity INFO ZONE-1051 Message , [ZONE-1051], ,, INFO, , The Interop Safe Zoning mode is set to Disabled. Probable Cause Indicates that the Interop Safe Zoning mode is disabled. Recommended Verify if the Safe Zoning mode change was done on purpose. Action Severity INFO Fabric OS Message Reference 765 53-1002448-01