HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 165

BL-1024 7 BL-1024 Message , [BL-1024], ,, INFO, , All ports on the blade in slot will be reset as part of the firmware upgrade. Probable Cause Indicates that a recent firmware upgrade caused the blade's firmware to be upgraded and resulted in the cold upgrade. As part of the upgrade, all datapath elements were reset. Recommended No action is required. Action Severity INFO BL-1025 Message , [BL-1025], ,, INFO, , All GigE/FCIP Virtualization ports on the blade in slot will be reset as part of the firmware upgrade. Probable Cause Indicates that a recent firmware upgrade caused the blade's firmware to be upgraded and resulted in the cold upgrade. As part of the upgrade, all GbE or Fibre Channel over IP (FCIP) or Virtualization data elements or FC Fastwrite ports were reset. Recommended No action is required. Action Severity INFO BL-1026 Message , [BL-1026], ,, CRITICAL, , Internal port offline during warm recovery, state (0x). Probable Cause Indicates that an internal port went offline during the warm recovery of the switch. The switch will reboot and start a cold recovery. Recommended Collect supportSave information, then restart the switch and run the diagPost command to ensure Action Power-On Self-Test (POST) is enabled. If the problem persists, replace the switch. Severity CRITICAL BL-1027 Message Probable Cause , [BL-1027], ,, CRITICAL, , Blade in slot faulted, boot failed; status 0x 0x 0x. Indicates that the blade failed to boot properly. Fabric OS Message Reference 79 53-1002448-01