HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 493

FW-1510 45 Recommended Reconfigure a valid e-mail address. Action Severity WARNING FW-1510 Message , [FW-1510], ,, WARNING, , threshold exceeded(High=). Current value is : Port disabled. Probable Cause Indicates that the specified port is now disabled because the link on this port had multiple link failures that exceed Fabric Watch threshold on the port. Both physical and hardware problems can cause link failures. Link failures frequently occur due to a loss of synchronization. Link failures also occur due to hardware failures, a defective small form-factor pluggable (SFP) or faulty cable. Protocol errors indicates CRC sum disparity. Occasionally, these errors occur due to software glitches. Persistent errors occur due to hardware problems. Recommended Check for concurrent loss of synchronization errors. Check the SFP and the cable. Then, enable the Action port using the portEnable command. Severity WARNING FW-1511 Message , [FW-1511], ,, INFO, , , , has crossed lower threshold boundary to in between(High=, Low=). Current value is . Probable Cause Indicates that the number of link failures that the port experiences has changed and crossed lower threshold boundary to a value within the acceptable range. Link loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware problems can cause link loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss of synchronization errors and, if applicable, troubleshoot them. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO Fabric OS Message Reference 407 53-1002448-01