HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 269

EM-1006 25 EM-1006 Message , [EM-1006], , FFDC, CRITICAL, , has faulted. Sensors below minimum limits. Probable Cause Indicates that the sensors show the voltage is below minimum limits. The switch or specified blade is being shut down for environmental reasons; the voltage is too low. Recommended Action If this problem occurs on a blade, it usually indicates a hardware problem on the blade; replace the blade. If this problem occurs on a switch, it usually indicates a hardware problem on the main board; replace the switch. Severity CRITICAL EM-1007 Message , [EM-1007], , FFDC, CRITICAL, , is being reset. Sensors has exceeded max limits. Probable Cause Indicates that the voltage on a switch has exceeded environmental limits. A reset is sent to the faulty slot or the switch (for nonbladed switches). Recommended Action There is most likely a voltage hardware problem on the blade or motherboard of the switch. For the Brocade DCX, 24000, and 48000, replace the blade field-replaceable unit (FRU). For the Brocade 3900 replace the motherboard FRU. For the Brocade 200E, 300, 3016, 3250, 3850, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000, 6510, 7500, AP7600, and Brocade Encryption Switch, replace the switch. Severity CRITICAL EM-1008 Message , [EM-1008], , FFDC, CRITICAL, , Unit in with ID is faulted, it is incompatible with the configuration, check FOS firmware version as a possible cause. Probable Cause Indicates that a blade inserted in the specified slot or the switch (for nonbladed switches) is not compatible with the platform configuration (includes the firmware version) or the switch configuration. The blade is faulted. Recommended Action If the blade is incompatible, upgrade the firmware or replace the blade and make sure the replacement blade is compatible with your control processor (CP) type and firmware. If the incompatibility is with the logical switch configuration, change the configuration using the lscfg command to be consistent with the blade type, or remove the blade. Severity CRITICAL Fabric OS Message Reference 183 53-1002448-01