HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 524

48 HIL-1501 Recommended Install the missing fan FRUs immediately. Action Severity WARNING HIL-1501 Message , [HIL-1501], ,, WARNING, , Slot , high temperature (). Probable Cause Indicates that the temperature of this blade has risen above the warning threshold. Recommended Action Run the fanShow command to verify all the fans are working properly. Make sure that the area is well-ventilated and that the room temperature is within operational range of your switch. Refer to the hardware reference manual for your switch for the operational temperature range. Severity WARNING HIL-1502 Message , [HIL-1502], , FFDC, CRITICAL, , Slot , high temperature (). Unit will be shut down in 2 minutes if temperature remains high. Probable Cause Indicates that the temperature of this blade has risen above the critical threshold. This usually follows a high-temperature message. Recommended Action Run the fanShow command to verify all the fans are working properly. Make sure that the area is well-ventilated and that the room temperature is within operational range of your switch. Refer to the hardware reference manual for your switch for the operational temperature range. If the message persists, replace the blade. Severity CRITICAL HIL-1503 Message , [HIL-1503], , FFDC, CRITICAL, , Slot , unit shutting down. Probable Cause Indicates that the temperature of this blade has been above the maximum threshold for at least two minutes. The blade is shut down to prevent damage. This usually follows a high-temperature warning message. Recommended Run the fanShow command to verify all the fans are working properly. Action 438 Fabric OS Message Reference 53-1002448-01