HP Brocade 8/24c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 144

5 AUTH-1012 AUTH-1012 Message , [AUTH-1012], ,, WARNING, , Authentication is rejected: port explain reason . Probable Cause Indicates that an authentication is rejected because the remote entity does not support authentication. Recommended Make sure the entity at the other end of the link supports authentication. Action Severity WARNING AUTH-1013 Message , [AUTH-1013], ,, WARNING, , Can not perform authentication request message: port , message code . Probable Cause Indicates that the system is running low on resources when receiving an authentication request. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING AUTH-1014 Message , [AUTH-1014], , FFDC, ERROR, , Invalid port value to : port . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR 58 Fabric OS Message Reference 53-1002448-01