HP ElitePad 1000 HP ElitePad 1000 G2 Maintenance and Service Guide - Page 84
System board, until the board rests at an angle, and then
View all HP ElitePad 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
4. Lift the bottom edge of the battery connector board (3) until the board rests at an angle, and then slide the board out of the opening in the front cover. 5. Remove the battery connector board and cable. Reverse this procedure to install the battery connector board. System board Description System board (includes docking connector and USB port) Spare part number 744032-001 Before removing the system board, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the Retail Jacket. 3. Disconnect all external devices from the Retail Jacket. 4. Remove the top cap (see Top cap on page 67). 5. If installed, remove the tablet from the Retail Jacket (see Top cap on page 67). 6. Remove the front cover (see Front cover on page 69). 76 Chapter 5 Removal and replacement procedures