HP ElitePad 1000 HP ElitePad 1000 G2 Maintenance and Service Guide - Page 87
Remove the Phillips PM1.9×3.0 screw
View all HP ElitePad 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
3. Release the ZIF connector (3) to which the right-side credit card reader board cable is attached, and then disconnect the right-side credit card reader board cable (4) from the left-side credit card reader board. 4. Remove the left-side credit card reader board. 5. Detach the right-side credit card reader board cable (1) from the rear cover. (The right-side credit card reader board cable is attached to the rear cover with double-sided adhesive.) 6. Remove the Phillips PM1.9×3.0 screw (2) that secures the right-side credit card reader board to the rear cover. Retail Jacket component replacement procedures 79
3.
Release the ZIF connector
(3)
to which the right-side credit card reader board cable is attached,
and then disconnect the right-side credit card reader board cable
(4)
from the left-side credit card
reader board.
4.
Remove the left-side credit card reader board.
5.
Detach the right-side credit card reader board cable
(1)
from the rear cover. (The right-side credit
card reader board cable is attached to the rear cover with double-sided adhesive.)
6.
Remove the Phillips PM1.9×3.0 screw
(2)
that secures the right-side credit card reader board to
the rear cover.
Retail Jacket component replacement procedures
79