HP LD4730 User Guide - Page 19

Installing the HP Frame System Sold Separately, BOTTOM, RIGHT

Get HP LD4730 PDF manuals and user guides View all HP LD4730 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

The rails are labelled TOP for the top in landscape position, BOTTOM for the bottom in landscape position, RIGHT for your right side as you face the front of the screen, and LEFT for your left side as you face the front of the screen. All the screw holes match for the one rail that goes to each side; no force is needed. Attempting to attach the wrong rail could damage the bezel. When you frame a single array, the numbers on the rails match at each corner: 1 2 2 1 3 4 4 3 To frame a single display, attach the top rail to the top of the display with three of the large (M4 x 10 mm) screws provided. The rail overlaps the bezel of the display. Attach the bottom, left, and right rails in the same manner, leaving the two small holes at each end open. Figure 3-10 Attaching rails Attach the four corner pieces with four small (M3 x 5 mm) screws each. These overlap the rails and secure their ends. Installing the HP Frame System (Sold Separately) 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
The rails are labelled
TOP
for the top in landscape position,
BOTTOM
for the bottom in landscape
position,
RIGHT
for your right side as you face the front of the screen, and
LEFT
for your left side as
you face the front of the screen. All the screw holes match for the one rail that goes to each side; no
force is needed. Attempting to attach the wrong rail could damage the bezel.
When you frame a single array, the numbers on the rails match at each corner:
2
3
1
2
3
4
4
1
To frame a single display, attach the top rail to the top of the display with three of the large (M4 x 10
mm) screws provided. The rail overlaps the bezel of the display. Attach the bottom, left, and right rails
in the same manner, leaving the two small holes at each end open.
Figure 3-10
Attaching rails
Attach the four corner pieces with four small (M3 x 5 mm) screws each. These overlap the rails and
secure their ends.
Installing the HP Frame System (Sold Separately)
13