HP Latex 3200 Users Guide - Page 130

● The substrate-load position is not used for printing: it may be used for loading thick substrates or for maintenance tasks. ● The printing position is a fixed height suitable for unwrinkled substrates up to 0.4 mm (0.016 in) thick. ● A custom position is used for substrates thicker than 0.4 mm (0.016 in), or for substrates that wrinkle slightly due to heating. We recommend setting the custom position as follows: - The thickness of the substrate plus 1.9 mm for substrates that do not wrinkle. - The thickness of the substrate plus 2 to 3 mm for substrates that wrinkle. You cannot exceed the maximum height permitted by the Internal Print Server. TIP: Try to avoid wrinkling by using substrates that do not wrinkle, or by using a slower print mode that will allow you to lower the drying and curing power. ● The ink collector install position is used only for installing the ink collector kit (see The ink collector kit on page 48); it is not used for printing. To set the carriage beam position, go to the Internal Print Server and select the appropriate position from the drop-down list. WARNING! Keep away from the printer's moving parts until the carriage beam has reached its new position. CAUTION: Do not change the carriage beam position while the printhead cleaning roll is out of place. 124 Chapter 4 Handle the substrate ENWW