HP Latex 3200 Users Guide - Page 50
Substrate edge holders for HP Latex 3000, 3100 and 3500, Install an edge holder on the HP Latex 3000
View all HP Latex 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
NOTE: The edge holders are not recommended when printing on substrate that is more than 0.4 mm (0.016 in) thick. TIP: The edge holders may be easier to deploy if you raise the carriage beam (see Set the carriage beam position on page 123); however, they can be deployed without raising the carriage beam. Substrate edge holders for HP Latex 3000, 3100 and 3500 The correct position is illustrated below. The substrate should be free to move, and should not touch the ends of the edge holder. CAUTION: Wrongly positioned edge holders could severely damage the printheads and carriage. NOTE: If the substrate is loaded with the right edge outside the 161 cm position on the spindle ruler, or the left edge outside the −162 cm position, the edge holders cannot be used because there is not enough space for them. NOTE: When printing with the Double-sided Day Night Kit, specific edge holders are also needed. Install an edge holder on the HP Latex 3000, 3100 and 3500 To install an edge holder, stand at the front of the printer and attach the front of the edge holder (marked with the number 1 on the blue part) to the front of the platen. Ensure that the substrate is aligned with the marks on the edge holder. 44 Chapter 4 Handle the substrate ENWW