HP ML150 HP ProLiant ML150 G6 Server Maintenance and Service Guide - Page 35
Replace the front bezel and access panel., Reconnect the power cords
UPC - 884420743644
View all HP ML150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
6. Using the provide surplus screws, install four screws. 7. Release the drive latch lever (Figure 3-8, 1). 8. Slide the new drive into the bay until it stops(Figure 3-8, 2). Figure 3-8 Installing an optical drive 9. Connect the power and data cables to the connectors on the rear of the new drive. 10. Replace the front bezel and access panel. 11. Reconnect the power cord(s) End of procedure. To remove an optical or tape drive, reverse the procedure above. Removal and replacement procedures 35
6.
Using the provide surplus screws, install four screws.
7.
Release the drive latch lever (Figure 3-8, 1).
8.
Slide the new drive into the bay until it stops(Figure 3-8, 2).
Figure
3
-8
Installing an optical drive
9.
Connect the power and data cables to the connectors on the rear of the new drive.
10.
Replace the front bezel and access panel.
11.
Reconnect the power cord(s)
End of procedure.
To remove an optical or tape drive, reverse the procedure above.
Removal and replacement procedures
35