HP Vectra XU 6/XXX HP Vectra XU 6/xxx Pc User’s Guide - d4369-90001 - Page 110
Using the Start-Up, Center, Parallel Ports and, Serial Ports
View all HP Vectra XU 6/XXX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
4 Troubleshooting Your PC and Using the Setup Program Using the HP Setup Program Using the Start-Up Center The Start-Up Center lets you choose which system devices the computer can start (boot) from. Some options will not be available if you selected Operating System . . . Microsoft Windows NT, OS/2, or Other. HP Vectra PC Setup xxx.xx.xxx.xx F1=Help On/Off Start-Up Center Control Start from Flexible Disk . . . Enabled/Disabled Start from CD-ROM Enabled/Disabled Start from Hard Disk . . . . . Enabled/Disabled Start with Network Enabled/Disabled Protocol Not used/Novell/Microsoft Priority Selected Priority 1 Flexible Drive Priority 2 IDE Hard Disk Priority 3 SCSI Hard Disk Priority 4 Network Parallel Ports and Serial Ports The Priority Selected items are for information only and cannot be changed. Use these options to select a combination of I/O address and IRQ channel for the parallel port and for the serial ports. To configure a parallel port mode, highlight Parallel Port Mode and select Centronics, EPP, or ECP. Parallel Port Parallel 1 (378h, IRQ7) Parallel Port Mode Centronics/EPP/ECP Serial Port A Serial 1/2/3/4/Off Serial Port B Serial 1/2/3/4/Off NOTE These options may not be available if Windows 95 is installed on your computer. 98 English