IBM 865741Y Handbook - Page 104

Attention: To ensure that the drive functions properly, do not overtighten the screws. 5. Install the drive into the lower drive bracket so that the power and signal cable connectors are facing the open side of the server. Align the screw holes and insert two screws on each side of the drive assembly near the bottom, as shown. Attention: a. If your server comes with a drive installed in bay 6, two screws are attached to each side of the drive assembly. If you remove a drive from bay 6 and install another drive in that bay, use the screws that come with the preinstalled drive. b. If you are installing a drive in bay 5, turn the drive upside down before you slide it into the bay. This ensures that the drive connector will align with and attach properly to the cable connector. When you install the four screws that come with the drive, attach them to the drive from the top. 86 Netfinity 3500 User's Handbook