IBM 865741Y Handbook - Page 225

Setting the Diskette Write-Protect Switch The diskette write-protect switch controls whether you can write information to a diskette using a diskette drive. The ability to prevent writing to a diskette is particularly useful if you are concerned about the security of information that can be obtained through a network. Note: This switch does not affect the ability to read information from a diskette. Before you begin: Read "Electrical Safety" on page 54 and "Handling Static-Sensitive Devices" on page 55. Turn off the server and all other connected devices. Disconnect all external cables attached to the server; then, remove the server cover (see "Preparing to Add Options" on page 56). 1. Locate the configuration switches (also known as rocker switches) on the system board. For more information, refer to the label inside the server, or see "System Board Illustration" on page 203. 2. For normal diskette operation or for read-only diskette operation, set switch 8 as shown in the following illustration. It might be helpful to use the end of a small screwdriver to set the switch. Normal Diskette Operation 12345678 ON OFF Read-Only Diskette Operation 12345678 ON OFF Chapter 7. Server Records and Specifications 207