IBM 865741Y Handbook - Page 85
Position the DIMM above the connector so that the two notches
View all IBM 865741Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Working with Memory Modules 3. Be sure that the retaining clips are in the open position, as shown in the following right-hand illustration. If the retaining clips are perpendicular to the connector, push outward on them until they click open. 4. Touch the static-protective package containing the DIMM to any unpainted metal surface in the server; then, remove the DIMM. 5. Position the DIMM above the connector so that the two notches on the bottom edge of the DIMM align properly with the connector. 6. Firmly push the DIMM straight down into the connector until the retaining clips close and snugly fit around both ends of the DIMM. Notches Chapter 4. Installing Options 67
Working with Memory Modules
3.
Be sure that the retaining clips are in the open position, as
shown in the following right-hand illustration.
If the retaining
clips are perpendicular to the connector, push outward on them
until they click open.
4.
Touch the static-protective package containing the DIMM to any
unpainted
metal surface in the server; then, remove the DIMM.
5.
Position the DIMM above the connector so that the two notches
on the bottom edge of the DIMM align properly with the
connector.
6.
Firmly push the DIMM straight down into the connector until
the retaining clips close and snugly fit around both ends of the
DIMM.
Notches
Chapter 4.
Installing Options
67